BeLuce Canada Inc., 3900 14th Avenue, Unit 1, Markham, ON L3R 4R3 P: (905) 948-9500 F: (905) 948-8673
926000540
TROUBLESHOOTING
EXIT SIGN DOES NOT COME ON AT ALL
1. Check AC supply and all AC connections - be sure exit has 24 hour AC supply (unswitched).
2. Check supply voltage and AC connections. The AC supply must be at least 80% of nominal (96V on a 120V line)
for equipment to function normally. At lower voltages the LEDs will begin to glow dimly until the source voltage
drops below the full “turn-on” point.
NOTE: This condition may also be caused by incorrectly connecting a 120 Volt supply line to the
277-Volt capacitor assembly lead.
3. AC supply is OK; replace LED circuit board assembly.
SAVE THESE INSTRUCTIONS
MAINTENANCE
1. Code requires that the equipment be tested every 30 days for 30 seconds, and that written records be maintained.
Further, the equipment is to be tested once a year for the duration required as per Code. The equipment is to be repaired
whenever the equipment fails to operate as intended during the duration test. Written records of test results and any
repairs made must be maintained. BeLuce Canada Inc. strongly recommends compliance with all Code requirements.
2. Clean exit face(s) on a regular basis.
NOTE: The servicing of any parts should be performed by qualified service personnel only. The use of replacement
parts not furnished by BeLuce Canada Inc., may cause equipment failure and will void the warranty.
Frame
Faceplate
Electrical
Junction Box
(supplied by
others)
Tilt out the bottom
of faceplate.
Lift up to remove
Remove Screw
Universal
Spiderplate
Sign Canopy
Chassis GND
LED Board
AC ONLY SIGN
Chassis GND
GREEN Ground
BLACK 120VAC
RED 347VAC or ORANGE 200-277VAC
WHITE Neutral
LED Board
AC & UNIVERSAL DC SIGN
YELLOW Positive 6 to 24VDC
PURPLE Negative
Emergency Supply
FROM Battery Pack
SELF-POWERED SIGN
Chassis GND
24 hours
Unswitched Supply
GREEN Ground
BLACK 105 to 360VAC
WHITE Neutral
LED Board
DUAL UNIVERSAL AC SIGN
From Generator OR
Emergency Supply
BROWN 105 to 360VAC
BLUE Neutral
NOTE: Cap unused AC Wire!
NOTE: Cap unused AC Wire!
24 hours
Unswitched Supply
GREEN Ground
BLACK 120VAC
RED 347VAC or ORANGE 200-277VAC
WHITE Neutral
24 hours
Unswitched Supply
Chassis GND
LED Board
NOTE: Cap unused AC Wire!
GREEN Ground
BLACK 120VAC
RED 347VAC or ORANGE 200-277VAC
WHITE Neutral
24 hours
Unswitched Supply
Ni-Cd
Battery
1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
TOLERANCES:
.X = .020
.XX = .010
.XXX = .005
.XXXX = .003
DRAWN BY
DATE
SIZE
SCALE
REV
SHEET
DWG NO
REF NO
DO NOT SCALE
on
2/28/2012
PART #
L D
1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
TOLERANCES:
.X = .020
.XX = .010
.XXX = .005
.XXXX = .003
DRAWN BY
DATE
SIZE
SCALE
REV
SHEET
DWG NO
REF NO
DO NOT SCALE
on
2/28/2012
PART #
L D
secure with
6 push nuts
1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
This document is the property of and contains information proprietary to Beghelli Canada, Inc. It is submitted in confidence and is to be used solely for the
purpose for which it was furnished and returned upon request. This document and such information is not to be reproduced, transmitted, disclosed, or used
otherwise in whole or in part without prior authorization of Beghelli Canda, Inc. The recepient's acceptance of this document shall be considered an
agreement to the foregoing.
UNLESS OTHERWISE SPECIFIED
ALL DIMENSIONS = INCHES
1/2
TOLERANCES:
.X =
.020
.XX =
.010
.XXX =
.005
.XXXX =
.003
3900 14Th. Avenue
Markham Ontario, L3R 4R3
Tel. # 905 948-9500 Fax # 905 948 8673
email: [email protected]
Web: http://www.beghelli.com
MATERIAL
FINISH
DRAWN BY
DATE
SIZE
SCALE
REV
SHEET
PART NAME
DWG NO
REF NO
DO NOT SCALE
10/22/2014
PART #
L D
Reflector
Figure 5
Figure 6
Figure 1
Figure 4
Figure 2
Figure 3
