Details of Programming Options
12
13
Signal Strength Meter
MeterSTD
(Standard meter)
The meter displays the band, and bar graph
showing signal strength. (factory default)
MeterTHT
(Threat Display
™
)
The meter simultaneously tracks multiple
radar signals and provides the relative signal
strength for each signal received.
MeterTEC
(TechDisplay)
The meter displays the actual numeric
frequency of the radar signal being received.
Note: See more details on page 8.
AutoMute
aMute ON
(AutoMute on)
In this setting, the RX75’s audio alerts will
initially be at the volume you set, but after a
few seconds, the RX75 will automatically
reduce the volume level, to keep you
informed, but not annoyed. (factory default)
aMuteOFF
(AutoMute off)
With AutoMute off, the RX75’s audio alerts
will remain at the volume you set for the
duration of the radar encounter.
Voice Alerts
Note: Voice is only available when the
optional speaker is installed.
VoiceON
(Voice announcements on)
In this setting, all radar and laser alerts,
including SWS messages, will be announced
in a digital voice, followed by the normal
tone. (factory default)
VoiceOff
(Voice announcements off)
In this setting, the standard tones will be
used.
City Mode Sensitivity
City STD
(Standard)
In this setting, when you put the RX75 in
the City mode, X-band sensitivity is
significantly reduced, to minimize
annoyance from X-band intrusion alarms
and motion sensors. (factory default)
City LoX
(Low X-band sensitivity)
In this setting, when you put the RX75 in
the City mode, X-band sensitivity is reduced
more than the standard setting. This will
reduce X-band alarms from other sources
even further, but also significantly
reduces range to X-band traffic radar.
City NoX
(No X-band sensitivity)
In this setting, when you put the RX75 in
the City mode, the RX75 will not respond to
any X-band signals.
WARNING: Only
choose this setting if you are
absolutely certain that there are no X-
band traffic radar units where you
drive.
Note: These settings only apply when the
RX75 is operated in City mode. X-band
sensitivity is not affected when used in
“AutoScan” or “Highway” modes.
Brightness
Brt AUTO
(Auto)
Display brightness automatically adjusted to
suit the ambient lighting in your vehicle.
Brt MIN
(Minimum)
Sets display to minimum brightness.
Brt MED
(Medium)
Sets display to medium brightness.
Brt MAX
(Maximum)
Sets display to maximum brightness.
Brt DARK
(Dark)
In this setting, the RX75 will only display a
very dim HD, AD, or CD for the power-on
indication, and will not show any visual
alerts when signals are detected.
Bands
BandsALL
In this setting, all radar, laser, and SWS
frequencies are monitored. This is the
factory default setting, and it is highly
recommended that you use your RX75 in
this mode.
BandsMOD
In this setting, the RX75 will warn you with
an audible alert and a text message, that one
or more bands have been turned off in
programming (i.e. “SWS OFF”). This
warning is displayed during the start-up
sequence (standard or fast).
WARNING: Do not disable a radar or
laser band unless you are certain it is
not used for speed measurement in
your area.
Details of Programming Options
