Push button
(63-DRW)
Multi-function button
(64-DRW)
1
Wireless streaming only applicable when using Beltone Direct accessories.
18
19
Multi-function button action
Default setting
New setting
Short press up
Increases volume
Short press down
Decreases volume
Long press up (3 seconds)
Changes programmes
Long press down (3 seconds)
Activates streaming
1
i
NOTE: If you have two hearing aids with the Synchronised Push Button enabled, programme chang-
es to one hearing aid automatically repeat in the second hearing aid. When you change a programme
in one hearing aid, it responds with one or more beeps. The same number of confirmation beeps in the
second aid follow. This Synchronised Push Button can also be configured to allow one side to control
volume increase and the other side to control volume decrease. The volume changes to one hearing aid
are repeated on the other side to keep the levels the same.
7.5 Operation of the hearing aid
7.5.1 Push button and Multi-function button
If you have hearing aids with a push button or multi-function button, this will allow you
to use up to four different listening programmes, each of them suitable for certain situ-
ations.
1. Tap the programme button to switch between programmes.
2. You will then hear one or more beeps. The number of beeps indicates which
programme you have selected (one beep = programme one, two beeps =
programme two, etc.).
3. When you turn the hearing aids off and then back on, they always return to the
default setting (programme one and pre-set volume).
Therefore, it should not be necessary to control the volume manually. However, in addi-
tion to controlling listening programmes, the multi-function button (64-DRW only) pro-
vides you with the ability to adjust the amplification to your liking.
The multi-function button is designed to change the volume or listening programmes of the hearing aids,
based on different ways it is pressed. If necessary, your hearing care professional can change the default
settings for the multi-function button and fill in the following table to indicate the new settings:
