Beltone myPAL Pro, Инструкция по эксплуатации

Страница: 19 / 27

36 37
• myPAL Pro may only be repaired by an authorized service
center.
• Do not use myPAL Pro in areas where RF transmission is pro-
hi-bited, e.g. air planes etc.
• Do only connect myPAL Pro to connections, which it is explic-
itly intended for.
Built-in battery care
i
Please observe the following if the product contains a battery
• Your product is powered by a rechargeable battery.
• The full performance of a new battery is achieved only after
two or three complete charge and discharge cycles.
• The battery can be charged and discharged hundreds of
times, but will eventually wear out.
• Unplug the charger from the electrical plug and the product
when not in use.
• If left unused, a fully charged battery will lose its charge over
time.
• Leaving the product in hot places, such as in a closed car
during hot summer conditions, will reduce the capacity and
lifetime of the battery.
• A product with a cold battery may not work temporarily, even
when the battery is fully charged. Battery performance is par-
ticularly limited in temperatures well below freezing.
Battery warning
i
• ”Caution” – The battery used in this product may present a risk
of fire or chemical burn if mistreated.
• Do not attempt to open the product or replace the battery.
It is built-in and not changeable. Use of other batteries may
present a risk of fire or explosion and the warranty will be ter-
minated.
• The battery in your product can not be removed or replaced
by the user. Any attempt to do so is risky and may result in
damage of the product.
• Only recharge the myPAL Pro with a power supply unit that
has been supplied together with the product.
• Dispose of batteries according to local regulations. Please re-
cycle when possible.
• Do not dispose the battery as household waste or in a fire as
it may explode.
• Batteries may explode if damaged.