Belshaw Brothers Donut Depositor N Series, Руководство оператора

Страница: 9 / 25

Belshaw Bros., Inc.
•
www.belshaw.com
•
Phone 206-322-5474
•
Fax 206-322-5425
2 MN-1542EN Donut Cutter Type N OM
2 Cleaning
To facilitate packaging, the Variety Cutter has
been partially disassembled and before use it
should be cleaned and properly assembled.
1. Wash plunger unit in hot water and
detergent, rinse and wipe dry. The
plunger should be lightly oiled with
cooking oil.
CAUTION : Never oil
donut machine parts by dipping in hot fat,
unless thoroughly dry.
2. Remove hopper base from hopper by
rotating base approximately ¼ turn to
release lock pin. Then pull down to
remove from hopper. Wash both hopper
and hopper base in water and detergent,
rinse and wipe dry. The cylinder lining
in the hopper base should be lightly oiled
with shortening.
3. Wash the crank assembly with a cloth
dampened with hot water and detergent.
Wipe off with another damp cloth to
remove detergent, and wipe dry.
DO
NOT IMMERSE THIS UNIT TO
WASH OR RINSE
.
Care, Maintenance, and
Cleaning for Plungers and
Hoppers
The plungers and hoppers of your Type K are
precision instruments built from alloy steels and
aluminum. They should be handled with care to
insure continued satisfactory performance.
When cleaning aluminum, selection of the right
type cleaner is your most important
consideration. Any household dish washing
detergent which is safe for aluminum does a
good job of cleaning and does not attack
aluminum. Strong Alkali cleaners, such as lye,
soda ash, and tri-sodium phosphate, will discolor
or even corrode aluminum even in weak
solutions.
DO NOT Handle roughly or drop on hard
surfaces.
DO NOT Mix with other utensils in the sink
when washing.
DO NOT Allow to rust. Always wash parts
thoroughly. Dry completely and lubricate with
mineral oil or liquid shortening before storing or
reinstalling in unit.
DO NOT Force the machine if it becomes
jammed. Disassemble and remove any
obstruction to prevent damage to the plunger.
Washing Plungers and
Hoppers by Hand:
1. Remove plunger from hopper.
2. Use plenty of warm water.
3. Add cleaner approved for aluminum in
concentrations recommended by
manufacturer.
4. Presoak to loosen stubborn or dried-on
deposits.
5. Use a non-scratching plastic scour cloth to
remove soil and restore luster.
6. Rinse in clear hot water (170-190 deg.)
7. Wipe completely dry.
8. Dip plungers in mineral oil or liquid
shortening to prevent rust and sticking.
NOTE: “O” Rings are not used on plungers
for Type K Depositors