BELLTEC TM48GRS, Руководство по установке и эксплуатации

Страница: 11 / 30

9
MOUNTING ON TRACTOR
1) THE BELLTEC DRILLING MACHINE hitch is made with the
proper spacing for Category I hitches (approxi-
mately 26"). If machine is being mounted on a
Category II hitch tractor (approximately 32" spac-
ing), prepare the tractor by changing rub blocks,
or sway chains, etc. so that hitch arms
will fit 26" spacing. Be sure drilling
machine hitch is equipped with correct
size pins for your tractors.
2) Align tractor lift arms with drilling
machine hitch pins and secure with lynch
pins.
3) INSTALLING HYDRAULIC TOP LINK (TM48HTL)
- Attach hydraulic top link to top link
bracket on tractor using the pin pro-
vided with the tractor.
4)
Plug hydraulic hoses for main lifting
and down pressure cylinders into
tractor hydraulic system.
5) Plug hydraulic hoses on top link into
tractor hydraulic system. Extend cyl-
inder rod to align ball joint with
bracket on drilling machine hitch and
secure with hitch pin provided. On
tractors with top link brackets with
multiple holes, such as the one in the
photograph at right, the operator
should choose a combination of tractor
top link bracket hole and hitch top
link bracket hole (see middle photo-
graph this page) such that when the top
link is approximately half extended,
the drilling machine will be close to
plumb and the skids will be 4”-6” off
the ground. (see bottom photograph this
page)
6) Adjust length of cylinder so hitch frame
is vertical and square with the ground.
7) INSTALLING LOCKBARS: Attach male shaft
half with ball joints to the extension
of the lower hitch pins, located to the
inside of the drilling machine hitch
(bottom Photograph this page) and secure
with lynch pins. Slide female tube half
of lockbars onto the shaft half and at-
tach to the pin located on the tractor
end of the hydraulic top link. (see
photograph)
MALE
LOCKBAR