If after pressing the button, you receive three “beeps” and no dial
tone, check the following:
1. BASE UNIT
is plugged into the power source.
2.
If you had a power failure or had unplugged the
BASE UNIT
, replace the
HANDSET
on the
BASE UNIT
for 2 to 5 seconds to reset the system.
Answering System does not work, check the following:
1. BASE UNIT
is plugged into the power source.
2.
Reset the system by pressing the
RESET
button at the side of the
BASE UNIT
.
Answering System does not answer calls, check the following:
1.
ANSWER ON/OFF LED indicator is lit.
Answers calls only after 10 rings, check the following:
1.
ANSWER ON/OFF LED indicator is lit.
2.
Message Memory is not full.
Does not respond to remote commands, ensure the following:
1.
Correct Remote Access Code is entered.
2.
A TONE telephone is being used.
Messages are incomplete, ensure the following:
1.
Message Memory is not full.
2.
Caller may be hesitating and pausing for more than 7 seconds.
Answers calls but does not record messages, check the following:
1. ANNC/ICM
switch is set to
ICM
.
2.
Memory is not full.
3.
Extension telephone was not picked up.
NOTE:
If none of the telephones in the house are working, disconnect one set at a time
t
o
verify that none of the telephones are causing the problem. If you still have a problem
after doing this, and your telephone still does not work, please contact your local phone
company.
Problem Solving
39
Содержание GH9486
Страница 54: ...Notes 45...
