Bell'O 8220, Руководство по установке, Страница: 16 / 21

After the holes are drilled, remove the
template and place the ALLIGATOR ®
Anchor (U) into the concrete wall as
shown in Figure 10.
After you have prepared the two holes for mounting the Wall Mount (WM), screw the two
bottom Lag Bolts (T) three-quarters of the way into the holes. Leave enough room so that you
can slip the wall mount over the screws. Install the wall mount as shown in Figures 8 and 11
without tightening the screws completely.
After the Wall Mount (WM) is on the wall, you can install the top Lag Bolt (T). First, use a
level to make sure the mount is vertically level. Then mark the center of the top securing
hole “c” (see Figure 7) with a pencil, and remove the wall mount from the wall. Using a drill
and the 5/16" (or 8mm) size drill bit, drill at least a 3" (76mm) deep hole through the top
securing hole mark. Next, insert the third ALLIGATOR ® Anchor (U) into the top securing
hole. You can now reinstall the wall mount and place the lag bolt into the securing hole “c”.
Leave some “wiggle room” so you can make any fine adjustments if necessary. Finally, tighten
all of the lag bolts completely.
Figure 10
U
English
Figure 11
WM
U
T
Concrete
3" (76mm) minimum
hole depth
15