Changing the radio key
If your Visit system is activated for no reason, there is probably a nearby system that triggers yours. In order to avoid radio
interference you need to change the radio key on all units. The radio key switches are located on the
transmitters
.
Here is how you change the radio key:
1
Open the transmitter cover and move any radio key switch to the up (on position) to change
the radio key. See
Changing the radio key
for the relevant transmitter.
2
Press and hold the function button on the pager until the green and yellow Visit LEDs blink
alternately. Release the button.
3
Press the test button/s on the transmitter within 30 seconds to send the new radio key.
4
All Visit LEDs on the pager blink 5 times to show that the radio key has been changed. It then returns to normal mode.
Note:
All Visit units must be set to the same radio key in order to operate as a group.
1
2
3
4
°
5
Visit pager receiver
Pager accessories
The pager can be complemented with the following accessories:
BE1260 Pager charger
Charges your pager during the night. Place it on the
bedside table and connect up to two bed shakers.
Note:
The pager will not vibrate when it’s charging,
but the Visit LEDs will act as usual.
BE1270 Bed shaker
Wakes you with vibrations if anything happens
while you are asleep. Connect it to the pager
charger and slide it under your pillow or mattress.
Warning!
When using the pager charger
ONLY USE RECHARGEABLE NiMH BATTERIES
in the pager.
Non-rechargeable batteries will start to leak if the pager is placed in the charger and the battery acid will
damage the electronics. The resulting damage is not covered by warranty.
BE1260
BE1270
On
Off
