Installation
Installation procedure
1
Select a location complying with the advice
in the Location and positioning section.
2
Remove the mounting bracket from the
smoke alarm by twisting it in an anti-clock-
wise direction, see Figure 6.
3
Place the mounting bracket on the ceiling
exactly where you want to mount the smoke
alarm. With a pencil, mark the location of the
two screw holes.
4
Taking care to avoid any electrical wiring in
the ceiling, drill holes using a 5.0 mm drill bit
through the center of the marked locations.
Push the plastic screw anchors provided into
the drilled holes. Make sure the flat side of the
bracket is flush with mounting surface, then
screw the mounting bracket to the ceiling.
5
Connect the supplied battery to the battery
snaps as shown in the
Quick start guide
on
page 5. Verify that the horn and LED on the
cover aluminate as indicated in the table on
the
Indication
summary
on page 4.
6
Place the smoke alarm unit on top of the
mounting bracket and twist it clockwise to
attach it. Install all the other alarms similarly.
7
Press the test button on each smoke alarm to
ensure that the smoke alarm unit works, see
Figure 7.
8
If you are using a supplementary Visit receiver,
also make sure that it lights up a fire symbol
in red and alerts with sound, flash or vibration
(depending on the type of Visit receiver you
are using). For more information, see the
Quick start guide
on page 5 and the Visit
receiver user manual.
Figure 6
Rotate the unit anti-clockwise.
Figure 7
11
