12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
7
GB
min 32 cm
max 80 cm
4
LA2501-050
T
T
5.3 CONNECTION OF DRAINAGE WATER
The curved end of drainage tube T, (supplied with the dishwasher) should be hooked onto the edge of
a sink or into a drainage pipe.
A special siphon should be used to prevent bad odours.
During the assembly, the following precautions should be taken:
- to avoid blockages, the drainage tube must not be bent;
- the tube’s end, relative to the top surface of the dishwasher (fig. 4), must be placed at a height
between 32 and 80 cm;
- the end of the tube must never be immersed in water;
- the drainage tube must not be extended to more than a maximum length of 1 metre. The extension
must have the same internal diameter. Furthermore, the maximum height at which the tube’s end
can be placed (in the case of an extended tube) must be reduced from 80 to 50 cm.
- If you use a drainage pipe, make sure its internal diameter is no less than to 4 cm.
5.4 ELECTRIC CONNECTIONS
The appliance may only be connected to a properly installed electric outlet with an
earth (ground) contact. The connection must be carried out in correspondence with
existing laws and regulations and supplementary rules issued by the supplier of
electric power.
The tension shown on the data tag must correspond to the power tension of the electric grid
at the site of installation.
Attention: the necessary characteristics of the electric supply grid are indicated on the
data tag.