Belling Built-In Electric with Microwave Oven, Руководство по обслуживанию, Страница: 23 / 95

USING THE PROGRAMMER / CLOCK - GAS
(if fitted)
The clock on this product has two modes
of operation, fully automatic or semi-
automatic. This product is intended for
use on the semi-automatic mode only. If
for some reason this mode has already
not been pre-set, the following procedure
should be used to set it to this mode:-
1. Turn the power off to the appliance for
30 seconds or more, then turn the power
on.
2. Within the first 6 seconds of turning
the power on, press the button for 1
second.
3. The operating mode “P2” can then be
selected using the plus or minus buttons.
4. The clock has now been set to semi-
automatic mode, any power fail situations
will not change the selected mode.
The programmer buttons
The ‘function’ button in the centre is used
for setting the minute minder and setting
up the automatic cooking. See below for
details.
To set the time of day
When the power is turned on to the
appliance, the time of day starts from
0.00.
Press and release the (minus) and
(plus) buttons simultaneously. Set the
time of day, eg 2.00 with the and
buttons while the ‘dot’ between the hours
and minutes is flashing.
To select an alarm tone
Press and hold the (minus) button
to listen to the first tone. Release the
button and press it again to listen to the
second tone, etc. Releasing the button
after the tone has sounded will
automatically select that tone.
Setting the minute minder
Press and release the function button. The
minute minder bell symbol will appear
and flash on the display. Use the plus and
minus buttons to set the required alarm
time. After setting, the display will revert to
show the time of day and the bell symbol
will stop flashing. Pressing the function
button will display the minutes remaining.
If the time has counted down to the last
minute, the remaining seconds are shown.
The tone will sound at the end of the time
set. To cancel the tone, press the function
button.