Bellfires Wi-Fi Box/Puck, Инструкция по установке и эксплуатации

Страница: 10 / 36

66 Connecting the Puck
1. Remove the lid of the battery compartment at the back of the Puck.
2. Put 2 batteries (type AAA, 1.5 Volt) in the battery compartment. Make sure the
batteries are put correctly as indicated in the battery holder.
3. Put the lid on the battery compartment.
4. On the Symax-2 receiver, press the Reset button (refer to the User Manual of the
appliance) until 2 beeps are heard.
5. After the second beep release the Reset button.
6. Within 20 seconds after release of the Reset button, press the ''-' button on the Puck.
Note: It is not necessary to connect the Puck again after the batteries have
been changed. The Puck stays connected with the receiver
Important: To prevent damage to the electronics, do not use metal tools to
remove the batteries.
Important:
• Remove old or dead batteries immediately to prevent damage to the Puck.
• Prevent exposure of the batteries to direct sunlight, too much heat, fire,
moisture of too much force.
• Make sure batteries are kept with their recommended temperature limits (0
ºC to 55 ºC).
• New and old batteries and different brands of batteries must not be used
together.
Connecting the Puck
10 Wifi Box