40
41
The Bellezi treatment chairs and beds are equipped with a remote control as standard.
FOUR FUNCTIONS
1. Adjusting back compartment.
! Important !
Make sure that when adjusting the back compartment the armrests
are always in the normal position, pointing forward!
2. Adjusting the seat up/down.
3. Adjusting the leg rests.
4. Tilt function.
THREE FUNCTIONS
1. Adjusting back compartment.
! Important !
Make sure that when adjusting the back compartment the armrests
(if present) are always in the normal position, pointing forward!
2. Adjusting the seat up/down.
3. Adjusting the leg rests.
Comment: In case of the Figo Podo SP3 the third function will not concern the adjustment of the leg rests
but the tilt function. The pictogram on the manual does not match the function.
C - INSTALLING FOOT CONTROL
(PART 2)
It may occur that your Bellezi specialist has not yet installed a T-cable. In that case, follow the following steps.
1. Disconnect the power plug.
2. Find out where the control box of your model is located
(See ‘Your product in a nutshell’)
.
3. Remove the plugs’ safety strips.
4. Remove the remote control plug from the control box and replace this plug with the T-cable.
5. With the T-cable you create two free ports in which you can connect both the manual control and the foot control.
6. Place the safety strip over the plugs of the control box.
7. Connect the manual control and/or the foot control to the T-cable.
Make sure you connect the plugs properly, and lock these with the special cable lock.
8. Connect the power plug to a power outlet.
9. Test all functions.
4 - USAGE
5 - CONTROLS