PAGE 3
OPERATIONS AND MAINTENANCE PROCEDURES
CONVEYOR TOASTER MODELS
JT2, JT2H, JT3, JT3H AND JT3BP
CLEANING PROCEDURE
Preventive Maintenance programs on your toaster will provide many years of production at full
capacity. Lack of Preventive Maintenance can shorten the life cycle of the toaster and/or result in
reduced capacities. The following cleaning guidelines should be performed as shown:
WARNING – ALWAYS DISCONNECT YOUR TOASTER FROM POWER
PRIOR
TO CLEANING OR MAINTENANCE
WARNING –
NEVER
SPRAY YOUR TOASTER WITH WATER.
NEVER
SUBMERGE INTO WATER.
Daily – 1) Clean the air intake area under the toaster with a slightly dampened cloth.
2) Wipe the conveyor surface and exterior surfaces.
3) Remove and wash the Crumb Tray and then replace the Crumb Tray.
Weekly - 1) Clean the air intake area under the toaster with a slightly dampened cloth.
2) Plug the toaster in but turn both Variable Heat Controls to the OFF position.
3) Turn the Conveyor Speed Control to fastest setting (100).
a. For lightly soiled conveyors belts, wipe with a damp cloth.
b. For heavily soiled conveyor belts, wipe with a light abrasive pad.
NEVER OPERATE YOUR TOASTER WITHOUT THE CRUMB TRAY IN PLACE
AS THIS MAY CAUSE OVERHEATING IN AND AROUND THE CONTROLS AND
MOTORS.
HIGH TEMPERATURE LIMIT
JT2 and JT3 Toasters are equipped with a special feature that prevents overheating. This feature
is re-settable by pushing the button located at the back of the control housing (opposite panel
from the front controls). Reach under the toaster and slide your hand to the rear of the bottom
panel and then up to the back of the housing. Feel around to the center of that back panel and you
will find the reset button. Push it and re-test your toaster.
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901