Programming and deleting the RFID cards
7
7
.
1
Manual programming of the RFID cards
When delivered from the factory, the
Touch Line
video panels do not have access cards memorized.
In order to have access in the building after installation, it is mandatory to program the RFID cards in the video panel as follows:
The entire video door phone system is installed and set under tension.
Go to the place where the
SCU
central unit of the installation is mounted.
Long press (2-3 sec.) the
PROG
button
The red LED turns on.
Return to the video panel with the RFID cards.
To program them, approach every card for one second to the
RFID area of the video panel.
For each programmed card, the panel issues two short beeps.
Repeat this step for programming all the RFID cards.
Go back to the place where the
SCU
central unit of the installation is mounted.
Short touch the
PROG
button to exit programming mode
The red LED turns off.
0
1
2
3
Note
: Use the same procedure for programming additional RFID cards.
7
.
2
Deleting the RFID cards
The entire video door phone system is installed and set under tension.
Go to the place where the
SCU
central unit of the installation is mounted.
Long press (2-3 sec.) the
PROG
button
The red LED turns on.
0
1
2
3
Go back to the place where the
SCU
central unit of the installation is mounted.
Short touch the
PROG
button to exit programming mode
The red LED turns off.
Return to the video panel and:
-
Long touch the
Fam. 1
key
Long beep.
-
Short touch the
Fam. 1
key
seven times
Two short beeps
confirmation.
-
Immediately after, long touch (2-3 sec.) the
Fam. 1
key
All the codes of the RFID access cards are deleted
permanently. The action is acoustically confirmed by a long beep.
EN
10
Connection of additional cameras
6
+
14
C/D
GND
Vin
C/D
GND
Vout
+
14
SCU
PROG
OUT1
+14
SCU.VDR03.BLG34
VSB
SCU
C/D
GND
Vout
+
14
Outdoor Panel
Video
selection
box
