H3OCTKTB2BSN
Bellagio By Airworks
4
Remove the heater from the packaging and place on a firm, level surface.
To operate, connect to properly polarized outlet only. Match wide blade of plug to wide slot and fully insert.
Be sure to plug into a 120V AC, 60Hz outlet. This heater will not operate until the unit is plugged in.
When the heater is plugged in a “beep” will sound once. The room temperature will be displayed until the
unit is unplugged.
For your convenience, the icons on the remote control and the actual heater have the same functions.
YOUR HEATER IS EQUIPPED WITH 4 CONTROL SETTINGS, THERMOSTAT AND TIMER.
POWER
Using button
Control
Result
1
st
Press
Power ON
LO indicator is illuminated and heater output is default on continuous low heat output (900W)
Current room temperature is displayed.
2
nd
Press
Power OFF
Heater will be powered OFF.
Allow 30 seconds for heater to come to a complete stop.
MODE
Using button
Control Setting
Displayed on LED
Use of Thermostat
1
st
Press
HIGH heat output
(1500W)
HI indicator is illuminated and heater output is
continuous and high (1500W)
Current room temperature is displayed.
Heat output is continuous.
Thermostat CANNOT be used at
this setting.
2nd Press
AUTO
heat output
AUTO indicator is illuminated and the
thermostat can be programmed to maintain
the desired temperature.
The current room temperature flashes on the
display.
Thermostat CAN be adjusted by
following instructions below
“THERMOSATAT*”
3rd Press
LOW heat output
(900W)
LO indicator is illuminated and heater output is
on continuous low heat output (900W)
Current room temperature is displayed.
Heat output is continuous.
Thermostat CANNOT be used at
this setting.
Additional presses
Heater cycles between HI/AUTO/LO
THERMOSTAT*
This heater is equipped with a thermostat to sustain the desired temperature. Follow the above directions
to set the heater on AUTO mode. The thermostat can only be used and adjusted while the heater is on
AUTO mode.
To adjust the thermostat using the control panel, set desired temperature by continuously pressing this
button on the unit. The temperature will be adjusted in 1°C(1°F) increments between 5°C(40°F) and
32°C(90°F). The default temperature setting is 24°C (75°F). The temperature will set and stop flashing
within 5 seconds of being adjusted. The current room temperature will reappear on the LED display.
To adjust the thermostat using the remote, press , followed by “ ” and “ ” to set the desired
temperature.
The LED can display temperature in ºF or ºC. Press the (
) and ( ) buttons on the unit together to switch
between ºF or ºC readout.
Once the room warms up to the set temperature, the heater will stop heating. The unit will continue after the
room temperature drops lower than the set temperature.
NOTE: It is normal, when using the thermostat, for your heater to cycle ON and OFF. The heater is
maintaining the set temperature for energy efficiency.
TIMER
This heater is equipped with a timer which can be set to countdown (1-8 hours) to automatic shutoff.
Pressing this button will flash and shuffle through time ranges of 1-8 hours in .5 hr increments. The time will
set and stop flashing after it is adjusted. To program the timer with the remote control, press and adjust
using the “ ” and “ ”.
The timer is displayed and the heater will begin countdown to automatic shut off. To deactivate timer, press
this button until 0.0 is displayed.
OPERATING INSTRUCTIONS
