7
BEFORE FIRST USE
The Whole Fruit Juicer comes almost completely assembled in the box.
1. Your Whole Fruit Juicer may be shipped with a protective cardboard insert
between the clear cover and the blade basket. Remove this and any other
protective packaging before using your Juicer.
2. Following the Disassembly Instructions, remove the food pusher from the feed
tube, then the cover, juice bowl with stainless steel blade unit.
3. Wash all removable parts (food pusher, clear cover, juice bowl, blade unit,
pulp basket, and juice collection jug with lid) in warm water with a mild detergent.
Rinse well and air-dry. This will eliminate any traces of dust or residue from
manufacturing or shipping.
CAUTION: Use care when handling the blade unit. Hold the filter by the plastic rim only.
DO NOT TOUCH the cutter blades. The cutter blades are very sharp!
CAUTION: Never rinse or immerse the Motor Base in water or any other liquid.
ASSEMBLY INSTRUCTIONS
WARNING: ALWAYS MAKE SURE THE WHOLE FRUIT JUICER IS UNPLUGGED BEFORE
STARTING ASSEMBLY.
IMPORTANT: The Juicer is equipped with a safety system that prevents the Juicer from
being turned ON unless the unit is completely and properly assembled.
1. Rotate the locking clamp so that it sits at the front of the base. (See Figure 1.)
2. Place the juice bowl on top of the motor base so that the juice spout fits into
the cut out at the front of the base. (See Figure 2.)
CAUTION: Use care when handling the stainless steel blade unit. Hold the filters
rim only. DO NOT TOUCH the cutter blades. The cutter blades are very sharp!
3. Set the stainless steel filter onto the motor hub in the centre of the juice bowl.
(See Figure 2.) Press down on the outer rim of the stainless steel filter until it
drops into place and is securely seated. Gently rotate the filter to ensure that it
turns freely. If initially it fails to seat, this should slip it into place. Double check
by pressing down on the rim and spinning it again.
4. Align the cover so that the pulp spout cover fits over the back of the base. Fit the
tab of the cover into the slot on the top of the juice bowl. (See Figure 3.)
5. Turn the food pusher so that the groove in the side lines up with the tab in the
feed tube. Insert the food pusher into the feed tube. (See Figure 4.) Store the food
pusher in the feed tube of the lid until the produce is ready to juice.
Juice
Collection Jug
Froth
Separator
Pulp Basket
Cover
Tab
Figure 1
Figure 2
Figure 3
