SECTION 574-504-720
Punch Assembly
3.06
To remove punch assembly:
(!)Perform paragraph 3.05 Steps 1, 2, 3, 6, 7,
9,
1 0 and 11.
@
Remove two remaining mounting screws.
Move punch assembly to left away from
center frame, disconnecting link from
transport assembly. (Care should be taken
not to lose shims on transport shaft.)
Note 1:
In reassembly, the Feed Pawl and Ratchet
Wheel Engagement adjustment must be made.
Note 2:
In reassembly connect link to transport
assembly while mounting punch to center frame.
PageS
•
Loosen mounting screw and remove
grounding strap. Remove mounting
screw with cable clamp.
FRAME
BELT·"O" RING
0
Disconnect two magnet
bank cable connectors.
(Part of 412325 Cable)
punch sensor connector.
(Part of 412325 Cable)
