•
To invoke scan mode, the following hot key sequence must be entered:
<ALT>+<CTRL>+<SHIFT> 0 <ENTER>
You will then hear a beep to confirm scan mode is taking place, and this can be verified visually by the
flashing lights on the currently selected computer port.
Setting the scan time on each port is done through the DIP switches found on the back of the OmniView:
DIP Switch Number
Scan Time
1
2
3
4
(seconds)
ON
ON
OFF
ON
3
OFF
ON
OFF
ON
10
ON
OFF
OFF
ON
20
OFF
OFF
OFF
ON
40
Quick Last/Next Switching mode
Quick Last/Next switching mode is similar to scan mode, except the operator has control over the switching.
In this mode, the operator can press either one of the shift keys to switch to the adjacent computer
previous or after the currently selected port. There is also no keyboard control during this mode, but the
mouse is still completely operable.
Note: Quick Last/Next switching mode will continue indefinitely, until the <SPACE> bar is pressed and is
terminated.
•
To invoke quick Last/Next switching mode, the following hot key sequence must be entered:
<ALT>+<CTRL>+<SHIFT> 9 <ENTER>
You will then hear a beep to confirm quick Last/Next switching mode is taking place, and this can be
verified visually by the slow blinking light on the currently selected computer port.
•
To select the next adjacent computer, press the RIGHT side <SHIFT> key.
•
To select the previous adjacent computer, press the LEFT side <SHIFT> key.
