9
seTTInG THe PrOdUCT UP
set Up the screenCast aV Transmitter
figure b
Connect the cable labeled “IR emitter” to the back of the transmitter.
Then route the four ends to the front of your video sources.
These will relay remote control commands from the ScreenCast
receiver. You will complete the setup of these in the section
“Setting Up the IR Emitters,” after the section on the receiver.
figure a
Connect your ScreenCast AV transmitter to the included
power supply and plug the power supply into an available
power outlet. Press the power button to turn it on.
Connect your HDMI AV source devices to the ScreenCast
AV receiver ports. Make sure all of your video sources
are plugged into power and are turned on.
Connect the IR emitter to the ScreenCast AV transmitter via the
3.5mm connection (it’s similar to a headphone jack). The four ends
of the emitter will relay commands from those devices’ remotes (from
ScreenCast receiver to transmitter to emitter to your devices).
hdmi
