17
Connecting and Configuring Your Message Manager
17
se
ct
io
n
2
1
3
4
5
6
7
8
9
10
11
12
Step 4 Configuring the Message Manager
4.1
The Wizard will now transfer all of
the configuration information to
the Message Manager. This will
take approximately one minute.
During this time, do not turn off the
Message Manager or computer. The
Message Manager will restart itself
at the end of this step.
4.2 Checking Internet
The Wizard will now check for an
Internet connection. This can take
a few minutes. The Wizard may not
detect a connection right away. If
not, it will retry a number of times.
The “Connected” light on the front
panel of the Message Manager will
flash during this time. Please be
patient through this process.
4.3 Finished
When the Internet connection is
complete, the Wizard will tell you
that you are finished. The “WAN”
LED on the front of the Message
Manager will be solid GREEN,
indicating that the Message
Manager is now connected to
the Internet.
Wait up to 5 minutes while the Message manager automatically registers
to the callEverywhere center. The phone connected to the Message
Manager will ring, confirming a connection was established. Answer the
call and follow the on-phone instructions. You will be directed to go to
www.everywhere.net
to sign up for your service.
Note:
if you do not receive a call, check whether your Internet settings
are correct. The Message Manager is pre-configured to obtain an IP
address automatically through DHCP. Verify that your DHCP function
is enabled.
Congratulations!
You have finished installing your new Message Manager!.
P74577_F1PG111EN_man.indd 17
5/28/04 5:12:40 PM
