Belden Grass Valley NV9603, Руководство пользователя, Страница: 49 / 67

39
NV9603
User’s Guide
Semi-Automatic Data Routing
A take involving a source or a destination having a machine control level might not occur
immediately if the source or destination device is in use.
This option applies in all operating modes.
If neither device is “in use” the take occurs immediately. Otherwise, you need to press the
source button again to complete the take.
If the source device is in use, the ‘Status’ display shows “Src Used” and the destination
display shows “Retry?”
If the source device is in use, the ‘Status’ display shows “DestUsed” and the destination
display shows “Retry?”
If the source device is in use, the ‘Status’ display shows “BothUsed” and the destination
display shows “Retry?”
If you do not press the (same) source button again, the take is canceled. (It will time out.)
Follow these steps:
1 Press a destination button.
2 Press a source button.
3 Examine the display.
4 If the destination display shows “Retry,” press the source button again to complete the
take. The take will time out if you do not press the source button.
Chop
The chop function is a diagnostic function for routers that support chop. It allows you to
switch rapidly between two sources at a particular destination. The chop interval is defined
in the NV9000 configuration. The default chop interval is 6
fields .
Follow these steps:
1 Press a destination button. The ‘Destination’ field of the display shows the destination
you chose. Scroll to the correct page if necessary.
2 Optionally press ‘Source Shift’ to toggle between the sets of sources.
3 Press a source button. This is the first source. Scroll to the correct page if necessary.
4 Press the chop button.
5 Optionally press ‘Source Shift’ to toggle between the sets of sources.
6 Press another source button. Scroll to the correct page if necessary. This is the second
source. The chop is immediately activated on the routers (of the default destination)
that support chop.
To terminate the chop, (1) press the chop button again to turn it off, (2) select the
destination you had chosen for the chop, then (3) select any source.
Salvo Mode
Your panel must be configured to have a salvo list and a salvo button. Otherwise, salvo
mode does not function.