Belden Grass Valley Kaleido-X, Инструкция по установке и обслуживанию

Страница: 144 / 216

144
System Configuration
Logging on to the Kaleido-RCP2
The Enable IP x parameter instructs the Kaleido-RCP2 to query the selected IP address
for a list of rooms.
5 Select Host IP ADDR , and then press ENTER.
6 Using the numeric keypad, type the IP address of a Kaleido Multiviewer on a remote
subnet, and then press ENTER.
7 Repeat step 4 to step 6 to add unicast IP addresses for up to three remote Kaleido
Multiviewer systems.
Logging on to the Kaleido-RCP2
As a network device, the Kaleido-RCP2 provides access to any room configuration on any
Kaleido Multiviewer system on the network. As a security measure, access is controlled by a
login procedure.
To log on to a Kaleido Multiviewer system from the Kaleido-RCP2
1 Press the LOGIN key.
The following message will appear on the LCD display:
LOGIN Position

Admin
2 Press ENTER to select “Admin”.
A message prompting you to enter a password will appear on the LCD display.
3 Press ENTER again (by default, there is no password).
The message “Access granted” will appear on the LCD display if the login is successful. If
a mouse is connected to the Kaleido-RCP2, then you should be able to see and move
the mouse pointer on the monitor wall.
For more information, refer to the Kaleido-RCP2 Guide to Installation and Operation . See
Related Documentation , on page 15.
Note:
If at any time the message “Target system is offline” or “No login list
available” appears on the LCD display, press the ESC, ENTER and DEL keys
simultaneously and go back to
step 1 .