Belden Grass Valley Kaleido-X, Инструкция по установке и обслуживанию

Страница: 143 / 216

143
Kaleido-X (7RU)
Installation & Service Manual
3 Press the ENTER key to display the ETHERNET OPTIONS menu.
4 Select the IP ADDRESS menu using the 2 key (to move up in the list) or the 8 key (to
move down the list), and then press ENTER.
5 Using the numeric keypad, type the chosen IP address, and then press ENTER.
6 Select the NETWORK MASK menu using the 2 key (to move up in the list) or the 8 key
(to move down the list), and then press ENTER.
7 Using the numeric keypad, type the chosen network mask, and then press ENTER.
You have assigned a static IP address to the Kaleido-RCP2.
Selecting a room for the Kaleido-RCP2
To select a room for the Kaleido-RCP2
1 Press and hold the ENTER button until the ESC button lights up, to display the
configuration menu.
2 In the ROOM SELECTION display, press ENTER again to get the room list from the
Kaleido Multiviewer systems that are currently available on the network.
3 In the room list, select the room you want to access by pressing the 2 key (to move up
in the list) or the 8 key (to move down the list).
4 When the appropriate room name is highlighted, press ENTER to accept the new
selection.
5 When prompted, log on to the selected room. See Logging on to the Kaleido-RCP2 on
page 144.
Connecting the Kaleido-RCP2 to Other Kaleido Multiviewer Systems
The unicast IP feature enables a Kaleido-RCP2 to find up to three Kaleido Multiviewer
systems on different subnets and connect to them (via network gateways), while
maintaining connections to Kaleido Multiviewer systems in its own subnet.
To configure a unicast IP address on the Kaleido-RCP2
1 Press and hold the ENTER button until the ESC button lights up, to display the
configuration menu.
2 Select ETHERNET OPTIONS on the LCD display, and then press ENTER.
3 Select Unicast host IP , and then press ENTER.
4 Select Enable IP 1 , and then press ENTER.
Note:
By default, a multiviewer’s video outputs are assigned to specific
rooms: the outputs are assigned to ROOM1.
Notes
• To navigate the Kaleido-RCP2 menu, press the 2 key to move up, or the 8
key to move down.
• There is no need to configure unicast IP addresses for Kaleido Multiviewer
systems on the same subnet as the Kaleido-RCP2.