Belden grass valley Kaleido-IP X120, Инструкция по установке и обслуживанию

Страница: 24 / 110

24
Multiviewer Cabling
Changing the Output Resolution
5 Connect the power cords, and then turn the power on. The power switch is located on
the front panel.
1
6 If you want to use a different display resolution, see Changing the Output Resolution ,
on page 24, for detailed instructions.
Changing the Output Resolution
To change a display’s resolution from the monitor wall
1 Connect a mouse to one of the
Kaleido-IP frame’s
USB ports. See Troubleshooting with
the Kaleido-IP frame’s USB ports , on page 96 for more information about this.
2 Right-click anywhere on the monitor wall, point to Monitor Wall (if you clicked a
monitor), and then click Display resolution .
• If your displays are not collocated with your Kaleido-IP unit, you may
choose to employ DXF-200 transmitter/receiver devices that allow you to
install a display up to 1,000 meters (3,300 feet) from the signal source. In
this case, use the provided DisplayPort-to-HDMI cable between the
Kaleido-IP and the DXF-200 transmitter module.

For more information on the:
DXF-200, refer to the DXF-200 DVI/HDMI Optical Extension System User’s
Manual .
See Related Documentation , on page 15.
1.The Kaleido Software does not support activating a soft shutdown from the Kaleido-IP frame’s power
button.
IMPORTANT
Should you want to add or replace a display or AV receiver at a later time,
make sure the multiviewer is powered off, before making these changes. In
the event that you have connected such a device while the multiviewer was
running, you must restart the multiviewer for audio monitoring to be
restored. Refer to
Restarting and Shutting Down a Kaleido-IP Multiviewer , in
the Kaleido Software User’s Manual. See Related Documentation , on
page 15.
Notes (continued)