29
iTX Playout Appliance 2
Installation and Service Manual
To remove and replace the SDI video I/O card(s) (Corvid LP):
1 Power down the system and remove power from the unit.
2 Disconnect all of the cables from the unit’s rear panel.
3 Remove the unit from the rack and place on a solid, flat surface.
4 Remove the top cover from the chassis.
5 On the right-side of the chassis’ rear panel, lift the two small levers to unlock the card
bracket from the chassis.
If your chassis model does not have these levers, remove the four screws (2 on rear, 2 on
top) that secure the card bracket to the frame.
6 Carefully lift the bracket upwards to remove the entire bracket from the chassis. The
cards remain attached to the bracket.
WARNING
- Power Disconnection
The system must be disconnected from all sources of power and the
power cord removed from the power supply module(s) before
accessing the chassis interior to install or remove system components. his
unit has more than one power supply connection. All connections must be
removed to de-energize the unit.
