18
Development Kit for EES20 and EES25
Release 1.0 03/2012
3 Changing the default IP-Address
There are two ways to change default IP-Address to establish a
connection:
►
By accessing serial communication RS-232 directly or,
►
By using device discovery software such as, Hirschmann’s
HiDiscovery tool.
3.1 Serial communication
Using the CLI Command, network parms, you set the IP Address,
subnet mask and the IP of the gateway IP router (optional). The IP
Address and the gateway must be in the same subnet.
□
In the User Exec mode enter: “enable” to change to the Privilege
Exec Mode.
□
In the Privilege Exec mode enter the command: network parms
<ipaddr><networkmask> [gateway]. The gateway entry is optional.
e.g. network parms 192.168.1.1 255.255.255.0
□
Any changes must be saved to the devices memory to be persistent
after a power cycle. Therefore, enter command: “save”
3.2 Hirschmann’s HiDiscovery Tool
Install the HiDiscovery software on your PC. The software is on the CD
supplied with the development kit. The HiDiscovery application uses the
first PC network card found. If your computer has several network cards,
you can select these from the HiDiscovery toolbar. The HiDiscovery
application provides an easy-to-use and effective way to set-up a
network profile on the EES.
Note: The software package WinPcap Version 3.1 is also included with
the installation of HiDiscovery.
