Beldeko DIEGO P200X2, Руководство по установке

Страница: 26 / 32

TO TEST
1. Turn the burner valve OFF.
2. Turn the liquid propane cylinder valve on counterclockwise to open the valve.
3. Apply the soap solution to all gas fittings. Soap bubbles would appear where a leak is
present.
4. If a leak is present, immediately turn the gas supply OFF and tighten leaky fittings.
5. Turn the gas back ON and recheck.
6. Should the gas continue to leak from any of the fittings, turn the gas supply OFF and
contact customer service.
USING THE OVEN
Each burner is rated at 4.0KW. To begin:
1. Make sure the oven has been leak tested and properly placed.
2. Remove any remaining packing material.
3. Light the burner using the LIGHTING INSTRUCTIONS below LIGHTING INSTRUCTION
TO LIGHT THE BURNER
1. Make sure the control knob is in OFF position,
and then turn the liquid propane cylinder valve ON
by slowly turning counterclockwise.
2. Push in and slowly turn the control knob
anticlockwise until you hear a click and the burner ignites.
3. If burner doesn’t light, turn the knob OFF, wait 5 minutes and repeat the lighting.
TO LIGHT WITH A MATCH
1. If burner will not light after several attempts using the control knob, the burner may be
lit with a match.
2. If you have already attempted to light the burner using the control knob, wait 5 minutes
for any gas to dissipate.
3 Insert a match into the matchstick holder, ignite the match and insert through the oven
opening to the burner.
4. Push and turn the control knob to HI slowly, the burner should ignite immediately.
5. If the burner does not light within seconds, turn the control knob OFF and wait 5 minutes
and try again.
3 - OPERATING INSTRUCTIONS