Bel Canto e.One Phono, Руководство пользователя, Страница: 6 / 10

Switch Settings
A set of 6 switches are located next to each RCA input. These are used to setup the optimum Gain, Resistive
Load, and Capacitive Load for your cartridge. Please refer to your cartridge manual for the optimum gain and RC
loading recommendations.
Note that you should MUTE your line stage
Preampilfier or analog input on your DAC and turn
the PHONO OFF before making any changes to the
rear panel switches.
We recommend using a small flat tip screwdriver such as used for attaching your cartridge to a tonearm or a
similar tool to gently change the switch positions.
Gain Setting Switches
The PHONO default gain setting will be for typical high output cartridges, from 3mV to 5mV nominal output levels
the 38 dB gain setting will be best. If you are using a low output 0.3mV Moving Coil cartridge, switch each channel
to the 60 dB setting by pressing the Gain Switches to the DOWN position. The interim positions can be used to
optimize setup for different cartridge and preamplifier sensitivities.
Ensure that you MUTE your line stage Preampilfier
or analog input on your DAC and turn the PHONO
OFF before changing this setting to prevent a large
transient from damaging your loudspeakers or
power amplifiers!
Input Resistor Load Setting Switches
The default input resistance is 47,000 (47K) ohms when all switches are in the UP position. When a switch is set
in the DOWN position the corresponding resistor value is placed in parallel to the 47K resistor, resulting in a lower
input resistance. This means that a large range of effective input resistance values can be selected by selecting
different parallel combinations of resistance value. The table on the following page can be used to determine the
switch positions for different input resistance values.
NOTE: Both channels have the same switch settings! The 2nd Switch next to the gain switch is not used
and can remain in the UP position.