Beko WTV 7531 X0, Руководство пользователя

Страница: 14 / 60

14 / EN
Washing Machine / User’s Manual
4.13 Progress of programme
Progress of a running programme can be followed from the
Programme Follow-up indicator. At the beginning of every programme
step, the relevant indicator light will turn on and light of the completed
step will turn off.
You can change the auxiliary functions, speed and temperature
settings without stopping the programme flow while the programme
is running. To do this, the change you are going to make must be
in a step after the running programme step. If the change is not
compatible, relevant lights will flash for 3 times.
C
If the machine does not pass to the spinning step, Rinse Hold
function might be active or the automatic unbalanced load
detection system might be activated due to the unbalanced
distribution of the laundry in the machine.
4.14 Loading door lock
There is a locking system on the loading door of the machine that
prevents opening of the door in cases when the water level is
unsuitable.
Loading door light will start flashing when the machine is switched to
Pause mode. Machine checks the level of the water inside. If the level
is suitable, Loading Door light illuminates steadily within 1-2 minutes
and the loading door can be opened.
If the level is unsuitable, Loading Door light turns off and the loading
door cannot be opened. If you are obliged to open the Loading Door
while the Loading Door light is off, you have to cancel the current
programme; see “Canceling the programme”.
Changing the selections after programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch the machine to pause
mode while a programme is running. The light of the step which the
machine is in starts flashing in the Programme Follow-up indicator to
show that the machine has been switched to the pause mode.
Also, when the loading door is ready to be opened, Loading Door
light will also illuminate continuously in addition to the programme
step light.
Changing the speed and temperature settings for auxiliary
functions
Depending on the step the programme has reached, you may cancel
or activate the auxiliary functions; see, “Auxiliary function selection”.
You may also change the speed and temperature settings; see, “Spin
speed selection” and “Temperature selection”.
C
If no change is allowed, the relevant light will flash for 3 times.
4.15 Adding or taking out laundry
Press the Start / Pause button to switch the machine to pause mode.
The programme follow-up light of the relevant step during which the
machine was switched into the pause mode will flash. Wait until the
Loading Door can be opened. Open the Loading Door and add or take
out the laundry. Close the Loading Door. Make changes in auxiliary
functions, temperature and speed settings if necessary. Press Start /
Pause button to start the machine.
4.16 Canceling the programme
To cancel the programme, turn the Programme Selection knob to
select another programme. Previous programme will be canceled.
End / Cancel light will flash continuously to notify that the programme
has been canceled.
Your machine will end the programme when you turn the Programme
Selection knob; however, it does not drain the water inside. When you
select and start a new programme, the newly selected programme
will start depending on the step the previous programme was
canceled in. For example, it may take in additional water or continue
to wash with the water inside.
C
Depending on the step where the programme was canceled
in, you may have to put detergent and softener again for the
programme you have selected anew.
4.17 Your machine is equipped
with a “Standby Mode”
In case of not starting any programme or waiting without making
any other operation when the machine is turned on by On/Off button
and while it is in selection step or if no other operation is performed
approximately 2 minutes after the programme you selected has
come to an end, your machine will automatically switch to energy
saving mode. Display brightness will decrease. In case of rotating the
Programme Selection knob or pressing any button, lights will restore
to their previous condition. This is not a fault.