39 / EN
Washing Machine / User’s Manual
a Pull the emergency draining hose out
from its seat
b Place a large container at the end of the
hose. Drain the water into the container
by pulling out the plug at the end of the
hose. When the container is full, block
the inlet of the hose by replacing the
plug. After the container is emptied,
repeat the above procedure to drain the
water in the product completely.
c When draining of water is finished,
close the end by the plug again and fix
the hose in its place.
d Turn and remove the pump filter.
If the product does not have an emergency water drain hose, in order to drain the
water:
a. In order to collect the water to flow out
of the filter, place a large vessel in front
of the filter.
b. Turn and loosen the pump filter until
water starts to flow (counterclockwise).
Fill the flowing water into the container
you have placed in front of the filter.
Always keep a piece of cloth handy to
absorb any spilled water.
c When the water inside the product is
finished, take out the filter completely
by turning it.
4 Clean any residues inside the filter as well as fibers, if any, around the pump impeller
region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If
it is one piece, seat the tabs in the lower part into their places first, and then press the
upper part to close.
