Beko WMB 51031 PL PT, Руководство пользователя

Страница: 51 / 57

54
EN
Draining any remaining water
and cleaning the pump filter
Filter system in your machine prevents
solid items such as buttons, coins and
fabric fibers clogging the pump propeller
during discharging of the washing
water. Thus, a good water discharge is
achieved and the pump life is extended.
• If your machine fails to drain the water,
the pump filter may be clogged. You
may have to clean it every 2 years or
whenever it is blocked plugged. Water
must be drained off to clean the pump
filter.
In addition, water may have to be drained
off completely in the following cases:
• before transporting the machine (e.g.
when moving house)
• when there is the danger of frost
In order to clean the dirty filter and
discharge the water;
1- Disconnect or unplug the machine from
the power supply.
A
There may be water at 90°C in the
machine. Therefore, the filter must be
cleaned only after the inside water
is cooled down to avoid hazard of
scalding.
2- Open the filter cap. The filter cap
may be composed of one or two pieces
according to the model of your machine.
If it is composed of two pieces, press
the tab on the filter cap downwards and
pull the piece out towards yourself.
If it is composed of one piece, hold it
from both sides and open it by pulling
out.
C
You can remove the filter cover
by slightly pushing the kick plate
downwards with a screwdriver, through
the gap above the filter cover.
3- An emergency drain hose is supplied
with some of our models. Others are not
supplied with this item.
If your product is supplied with an
emergency drain hose, do the following
as shown in the figure below:
• Pull out the pump outlet hose from its
housing.
• Place a large container at the end of
the hose. Drain the water off into the
container by pulling out the plug at the
end of the hose. If the amount of water
to be drained off is greater than the
volume of the container, replace the
plug, pour the water out, then resume
the draining process.
• After draining process is completed,
replace the plug into the end of the
hose and fit the hose back into its
place.
If your product is not supplied with an
emergency drain hose, do the following
as shown in the figure below:
• Place a large container in front of the
filter to receive water flowing from the