Beko WM5122W, Инструкция по установке и эксплуатации

Страница: 10 / 40

EN
Connecting to the drain
t 5IFFOEPGUIFESBJOIPTFNVTUCF
directly connected to the wastewater
drain or to the washbasin.
A
:PVSIPVTFXJMMCFGMPPEFEJGUIF
hose comes out of its housing
during water discharge. Moreover,
there is risk of scalding due to high
washing temperatures! To prevent
such situations and to ensure smooth
water intake and discharge of the
machine, fix the end of the discharge
hose tightly so that it cannot come
out.
t 5IFIPTFTIPVMECFBUUBDIFEUPB
IFJHIUPGBUMFBTUDNBOEDN
at most.
t *ODBTFUIFIPTFJTFMFWBUFEBGUFS
laying it on the floor level or close
UPUIFHSPVOE MFTTUIBODN
above the ground), water discharge
becomes more difficult and the
laundry may come out excessively
wet. Therefore, follow the heights
described in the figure.
t 5PQSFWFOUGMPXJOHPGEJSUZXBUFSCBDL
into the machine and to allow for easy
discharge, do not immerse the hose
end into the dirty water or drive it in
UIFESBJONPSFUIBODN*GJUJTUPP
long, cut it short.
t 5IFFOEPGUIFIPTFTIPVMEOPUCF
bent, it should not be stepped on
and the hose must not be pinched
between the drain and the machine.
t *GUIFMFOHUIPGUIFIPTFJTUPPTIPSU
use it by adding an original extension
hose. Length of the hose may not be
longer than 3.2 m. To avoid water leak
failures, the connection between the
extension hose and the drain hose of
the product must be fitted well with
an appropriate clamp as not to come
off and leak.
Adjusting the feet
A
In order to ensure that the product
operates more silent and vibration-
free, it must stand level and balanced
on its feet. Balance the machine by
BEKVTUJOHUIFGFFU0UIFSXJTFUIF
product may move from its place
and cause crushing and vibration
problems.
-PPTFOUIFMPDLOVUTPOUIFGFFUCZ
hand.
"EKVTUUIFGFFUVOUJMUIFQSPEVDU
stands level and balanced.
3. Tighten all lock nuts again by hand.
A
Do not use any tools to loosen the
lock nuts. Otherwise, they will get
damaged.
Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the
values in the "Technical specifications"
table. Our company shall not be liable