Beko WM 8063 CW, Инструкции по установке и эксплуатации, а также рекомендации по стирке

Страница: 28 / 40

28
EN
1. Close the taps.
2. Remove the nuts of the water intake
hoses to access the filters on the
water intake valves. Clean them with
an appropriate brush. If the filters are
too dirty, take them out by means of
pliers and clean them.
3. Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly
under running water.
4. Replace the gaskets and filters
carefully in their places and tighten
the hose nuts by hand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents
solid items such as buttons, coins and
fabric fibers clogging the pump impeller
during discharge of washing water. Thus,
the water will be discharged without any
problem and the service life of the pump
will extend.
If the machine fails to drain water, the
pump filter is clogged. Filter must be
cleaned whenever it is clogged or in every
3 months. Water must be drained off first
to clean the pump filter.
In addition, prior to transporting the
machine (eg., when moving to another
house) and in case of freezing of the
water, water may have to be drained
completely.
A Foreign substances left in the pump
filter may damage your machine or
may cause noise problem.
In order to clean the dirty filter and
discharge the water:
1. Unplug the machine to cut off the
supply power.
A
Temperature of the water inside
the machine may rise up to 90 ºC.
To avoid burning risk, filter must
be cleaned after the water in the
machine cools down.
2. Open the filter cap.
If the filter cap is composed of two
pieces, press the tab on the filter cap
downwards and pull the piece out
towards yourself.
If the filter cap is one piece, pull the cap
from both sides at the top to open.
C You can remove the filter cover by
slightly pushing downwards with a
thin plastic tipped tool, through the
gap above the filter cover. Do not
use metal tipped tools to remove the
cover.
3. Some of our products have
emergency draining hose and some
does not have. Follow the steps
below to discharge the water.
Discharging the water when the product
has an emergency draining hose:
a. Pull the emergency draining hose out
from its seat
b. Place a large container at the end
of the hose. Drain the water into
the container by pulling out the plug