Beko WM 6103 W, Инструкция по установке и эксплуатации

Страница: 10 / 40

10
EN
• In case the hose is elevated after
laying it on the floor level or close to
the ground (less than 40 cm above the
ground), water discharge becomes
more difficult and the laundry may
come out excessively wet. Therefore,
follow the heights described in the
figure.
• To prevent flowing of dirty water back
into the machine and to allow for easy
discharge, do not immerse the hose
end into the dirty water or drive it in the
drain more than 15 cm. If it is too long,
cut it short.
• The end of the hose should not be
bent, it should not be stepped on and
the hose must not be pinched between
the drain and the machine.
• If the length of the hose is too short,
use it by adding an original extension
hose. Length of the hose may not be
longer than 3.2 m. To avoid water leak
failures, the connection between the
extension hose and the drain hose of
the product must be fitted well with an
appropriate clamp as not to come off
and leak.
Adjusting the feet
A In order to ensure that the product
operates more silent and vibration-free,
it must stand level and balanced on its
feet. Balance the machine by adjusting
the feet. Otherwise, the product
may move from its place and cause
crushing and vibration problems.
1. Loosen the lock nuts on the feet by
hand.
2. Adjust the feet until the product stands
level and balanced.
3. Tighten all lock nuts again by hand.
A Do not use any tools to loosen the lock
nuts. Otherwise, they will get damaged.
Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the
values in the "Technical specifications"
table. Our company shall not be liable
for any damages that will arise when the
product is used without grounding in
accordance with the local regulations.
• Connection must comply with national
regulations.
• Power cable plug must be within easy
reach after installation.
• The voltage and allowed fuse or
breaker protection are specified in the
“Technical specifications” section. If the
current value of the fuse or breaker in
the house is less than 13 Amps, have
a qualified electrician install a 13 Amp