11 / EN
Washer-Dryer / User’s Manual
3
2
1
1 Use a tool to
loosen all bolts until
they rotate freely.
3
2
1
2 Remove the transit
bolts by turning
them slightly.
3
2
1
3 Attach the plastic
covers supplied in
the user manual
bag into the holes
on the rear panel.
C
INFORMATION
•
Keep the transit bolts in a safe place
to reuse when the product needs
to be moved again in the future.
•
Never move the product without the
transit bolts properly fixed in place!
3.4 Connecting water supply
C
INFORMATION
•
The water supply pressure required to
run the product is between 1 to 10 bars
(0.1 – 1 MPa). It is necessary to have
10 – 80 liters of water flowing from the
fully open tap in one minute to have your
product run smoothly. Attach a pressure
reducing valve if water pressure is higher.
A
CAUTION!
•
Models with a single water inlet should
not be connected to the hot water
tap. In such a case the laundry will get
damaged or the product will switch to
protection mode and will not operate.
•
Do not use old or used water inlet
hoses on the new product. It may
cause stains on your laundry.
1
2
3
1 Connect the special
hose supplied
with the product
to the water inlet
on the product.
A
CAUTION!
•
Ensure that the cold water connection
is made correctly when installing the
product. Otherwise, your laundry
will come out hot at the end of the
washing process and wear out.
1
2
3
2 Tighten the hose
nuts securely
by hand. Never
use a tool when
tightening the nuts.
1
2
3
3 Open the taps
completely after
making the hose
connection to
check for water
leaks at the
connection points.
If any leak occurs, turn off the tap and
remove the nut. Retighten the nut carefully
after checking the seal. In order to prevent
the water leaks, keep the taps closed
when you do not use the product.
