Beko RCNE720E3VZP, Руководство пользователя

Страница: 8 / 221

7 /25 EN
Refrigerator / User Manual
3
Installation
3.1. Appropriate location for installation
Contact an Authorized Service for the installation of the
product. In order to prepare the product for use, refer the
information in the user manual and ensure that electrical
installation and water installation are appropriate. If not,
call a qualified electrician and technician to have any
necessary arrangements carried out.
B
WARNING:
Manufacturer shall not
be held liable for damages that may
arise from procedures carried out by
unauthorized persons.
B
WARNING:
Product must not be plugged
in during installation. Otherwise, there is
the risk of death or serious injury!
A
WARNING:
: If the door clearance of the
room where the product will be placed is
so tight to prevent passing of the product,
contact the authorised service provider.
• Place the product on a level floor surface to prevent
jolts.
• If you are going to use the product in a cabin/furniture,
there must be a clearance of at least 2 cm between
the side walls and the cabin/furniture.
• Install the product at least 30 cm away from heat
sources such as hobs, heater cores and stoves and at
least 5 cm away from electrical ovens.
• Product must not be subjected to direct sun light and
kept in humid places.
• Appropriate air ventilation must be provided around
your product in order to achieve an efficient operation.
If the product is to be placed in a recess in the wall,
pay attention to leave at least 5 cm distance with the
ceiling and the side walls.
•
In environments where the room temperature drops
below 10°C, the refrigerator will continue to run to
preserve the food in the freezer. However, fresh food
in the fridge compartment might freeze due to the
cold environment.
3.2. Installing the plastic wedges
Plastic wedges supplied with the product are used to
create the distance for the air circulation between the
product and the rear wall.
1.
To install the wedges, remove the screws on the
product and use the screws supplied together with
the wedges.
2.
Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.