Microwave Oven / User Manual
12 / EN
3
Installation and connection
3.1 Installation and connection
•
Remove all packing material and accessories.
Examine the oven for any damage such as dents
or broken door. Do not install if oven is damaged.
•
Remove any protective film found on the micro-
wave oven cabinet surface.
•
Do not remove the light brown Mica cover that is
attached to the oven cavity to protect the mag-
netron.
•
Select a flat surface that provides sufficient
space for inlet and outlet ducts.
20cm
30cm
20cm
min85cm
20cm
•
Minimum installation height is 85 cm.
•
Rear surface of the appliance should not be
placed against a wall. Leave a clearance of min.
30 cm above the oven; the minimum distance
between the oven and adjacent walls, if any,
should be 20 cm.
•
Do not remove the spacers beneath the oven.
•
Obstructing the inlet and outlet openings may
damage the oven.
•
The appliance is fitted with a plug and must only
be connected to a properly installed grounded
socket.
•
The mains voltage must correspond to the volt-
age specified on the rating plate.
•
If the plug is no longer accessible after installa-
tion, an all-pole isolating switch must be present
on the installation side with a contact gap of at
least 3 mm.
•
Adapters, multi-way sockets and extension
cords must not be used. Overloading can result
with a risk of fire.
A
WARNING:
Do not place the oven
onto a hob or any other appliance
that emits heat. Placing the oven
on or close to a heat resource may
damage the oven and consequently,
the warranty will become void.
The accessible surface may be hot
during operation.
C
Do not trap or bend the power cable.
C
For built-in use, refer to the in-
stallation information con-
tained in kit with the model code
MOK 20232 X.
3.2 Radio interference
C
Operation of the microwave oven
may cause interference on radios,
TVs and similar appliances.
•
Place the oven as far away from radios and TVs
as possible. Operation of microwave oven may
cause interference to your radio or TV reception.
2. Plug your oven into a standard household out-
let. Be sure the voltage and the frequency is the
same as the voltage and the frequency on the
rating plate.
•
In case of interference, it may be reduced or
eliminated by taking the precautions given
below:
•
Clean the door and sealing surface of the oven.
•
Set the antenna direction of the radio or TV
again.
•
Reposition the oven based on the location of the
receiver.
•
Place microwave oven away from the receiver.
