Beko HITY 854310F, Руководство пользователя

Страница: 31 / 72

31 / EN
Washer-Dryer / User’s Manual
Select Additional Water or Extra Rinse
auxiliary functions. Use Cottons
programme
without pre-wash. Set
the temperature to the
level recommended on the drum cleaning
agent which can be found in the detergent aisle
in supermarkets . Apply this procedure without
any laundry in the product . Before starting
the programme, put 1 pouch of special drum
cleaning agent (if the special agent could not
be supplied, put max. 1 tea-cup of (max. 100
g) of antilimescale powder) into the main wash
detergent compartment. If the antilimescale is
in tablet form, put only one tablet into the main
wash compartment no. "2". Dry the inside of
the bellow with a clean piece of cloth after the
programme has come to an end.
C
INFORMATION
• Repeat Drum Cleaning process
in every 2 months.
• Use an anti-limescale suitable
for the washing machines.
After every washing and drying make sure that
no foreign substance is left in the drum.
If the holes on the bellow shown in the figure are
blocked, open the holes using a toothpick.
C
INFORMATION
• Foreign metal substances will cause
rust stains in the drum. Clean the
stains on the drum surface by using
cleaning agents for stainless steel.
Never use steel wool or wire wool.
A
CAUTION!
• Never use sponge or scrub materials.
These will damage the painted,
chrome and plastic surfaces.
6.3 Cleaning the body
and control panel
Wipe the body of the machine with soapy
water or non-corrosive mild gel detergents as
necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel.
6.4 Cleaning the water
intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreign substances and dirt in the water to enter
the washing machine. Filters should be cleaned
if they are dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to
access the filters on the water intake valves.
Clean residues on them with an appropriate
brush. If the filters are too dirty, remove them
from their places with a pliers and clean in this
way.
3. Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under running water.
4. Replace the gaskets and filters carefully in
their places and tighten the hose nuts by
hand.