Beko HDMI 32400 DT, Руководство пользователя

Страница: 11 / 21

11/EN
During installation of your induction hob, place the
product parallel to the installation surface. Also, apply
sealing gasket to the parts of the hob contacting the
counter as described below in order to prevent any
liquid from penetrating between the product and the
counter.
1. Prepare the surface of the counter as shown in
the figure.
2. Turning the hob upside down, place it on a flat
surface.
3. When installing the hob, apply the sealing gasket,
which was provided in the packaging, around the
hob as shown in the following picture, ensuring
that it remains 1 to 2 mm inside from the outer
edge of the glass.
4. Place the hob on the counter and align it.
5. Using the installation clamps secure the hob by
fitting through the holes on the lower casing.
1 Hob
2 Installation clamp
3 Counter
When installing the hob onto a cabinet, a shelf
must be installed in order to separate the
cabinet from the hob as illustrated in the above
figure. This is not required when installing onto
a built-under oven.
For example, if it is possible to touch the bottom of the
product since it is installed onto a drawer, this section
must be covered with a wooden plate.
* min. 15 mm
Rear view (connection holes)
Location of the connection holes shown in the
below figure are schematic,may vary
depending on the product model. Fix them
according to connection holes on your product.
1 Terminal Block
2 Assembly clamp
DANGER:
Making connections to different holes is not a
good practice in terms of safety since it can
damage the gas and electrical system.
DANGER:
There are gas and electrical components
contained within this hob, therefore when
fitting the mounting springs/clamps only attach
the supplied fixings to the connection holes
shown in this manual. Failure to observe this
advise may lead to life and property safety