Beko DV 7110, Руководство пользователя, Страница: 33 / 68

33 / EN
Dryer / User Manual
3 Installation
Refer to the nearest Authorised Service Agent
for installation of your product.
C
Preparation of location and
electrical installation for the
product is under customer’s
responsibility.
B
Installation and electrical
connections must be carried out by
a qualified personnel.
A
Prior to installation, visually check
if the product has any defects on
it. If so, do not have it installed.
Damaged products will cause risks
for your safety.
3.1 Appropriate installation
location
• Install the product in an environment
which has no risk of freezing and is in a
stable and level position.
• Operate your product in a well ventilated,
dust-free environment.
• Do not block the air ducts in front of and
under the product with materials such as
long pile rugs and wooden bands.
• Do not place your product on a long pile
rug or on similar surfaces.
• Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
• Once the product is installed, it should stay
at the same place where its connections
have been made. When installing the
product, make sure that the rear wall of
it does not touch anywhere (tap, socket,
etc.) and also pay attention to install
the product at a place where it will stay
permanently.
B
Do not place the product on top of
the power cable.
• Keep at least 1.5 cm distance to walls of
other furniture.
• The rear surface of the tumble dryer shall
be placed against a wall.
3.2 Under counter installation
• A special part (Part no: 295 970 0100)
replacing the top trim must be provided
and installed by the Authorised Service
Agent in order to use the machine under
a counter or in a cupboard. It should never
be operated without the top trim.
• Leave at least 3 cm of space between the
side and rear walls of the product and
the walls of the counter/cupboard when
installing your product under a counter or
in a cupboard.
3.3 Ventilation hose and
connection (for products
equipped with an outlet vent)
Ventilation hose allows exhaust air from
inside the machine
Vented dryer has 1 air outlet.
Stainless sheet metal or aluminum pipes can
be used instead of a hose. The pipe diameter
should be minimum 10 cm.
Maximum hose and pipe lengths are given in
the table below.
Hose Pipe
Maximum length 4 m 5 m
1 elbow 45° -1.0 m -0.3 m
1 elbow 90° -1.8 m -0.6 m
1 elbow 90° short -2.7 m
1 wall passage -2.0 m -2.0 m
C
Each elbow and other passages
should be subtracted from the
maximum length stated above.
To connect a ventilation hose;
1. Connect the air outlet hose to the
hose spacer piece by turning it
counterclockwise.
2. Make the hose passages as shown below.
C
Exhaust of humid air from the
dryer into the room is inconvenient.
It may damage the walls and
furniture in the room.
C
The ventilation hose can be routed
outdoors via a window or it can be
connected to the air outlet in the
bathroom.