Beko DIS39020, Инструкция по эксплуатации

Страница: 11 / 42

8
EN
Connection to the drain
Water discharge hose can directly
be connected to the drain hole or
sink’s drainage. The length of this
connection must be min. 50 cm and
max. 100 cm from the floor.
A discharge hose longer than 4
meters causes dirty washing.
Attach the water discharge hose to
the drainpipe without bending it.
Tightly fix the water discharge hose
to the drainpipe in order to prevent
any dislocation of the water discharge
hose during operation of the product.
C
Drainpipe must be connected to
the sewage system and it should
not be connected to any surface
water.
sludge accumulation at the end of
washing.
Permitted water temperature: up
to 25°C
The dishwasher may not be
connected to open warm water
devices or flow-through water
heaters.
•
Do not use old or used water inlet
hose on the new product. Use the
new water inlet hose supplied
with the product.
•
Connect the water inlet hose
directly to the water tap.
Pressure coming from the tap
should be minimum 0.3 and
maximum 10 bars. If the water
pressure exceeds 10 bars, a
pressure relief valve should be
installed in between.
C
Use a screw-on hose connector to
connect the water inlet hose to a
water tap with a ¾ inch external
thread. If required, use a filter
insert to filter deposits from the
pipes.
•
Open the taps completely after
making the connections to check
for water leaks.
A
For your safety, close the water
inlet tap completely after the
washing programme is over.