34/EN
There might be residues of detergent
or rinse aid in the machine and/or on
the pieces being washed depending
on the step the programme you have
cancelled was in.
Salt indicator ( )
Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears
on the display of your machine.
Adjusting the water hardness level is
explained in Water Softening System
section.
Rinse Aid indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
Adjusting the amount of rinse
aid
1.
After turning on the machine,
press and hold Time Delay and P keys
simultaneously for 3 seconds to enter the
settings menu.
2. Press P key until the drying indicator
starts flashing
3. Set to the appropriate level with the
Time Delay key.
4. Press the On/Off key to save.
No rinse aid dispensed in P:1 position
1 dose of rinse aid is dispensed in P:2
position.
2 doses of rinse aid are dispensed in P:3
position.
3 doses of rinse aid are dispensed in P:4
position.
End of programme
End of Programme indicator will light up
once the washing programme is over.
1. Press the On/Off key to turn off your
machine.
2. Close the tap.
3. Unplug the machine from the socket.
For energy saving, the machine is
automatically turned off following the
completion of the programme or if the
programme is not started.
Leave your dishes in the machine for
about 15 minutes to allow them cool
down after they are washed. Your
dishes will dry in a shorter time if you
leave the door of your machine ajar
during this period. This process will
increase the drying effectiveness of
your machine.
Water cut-off warning
If mains water is cut or water inlet tap is
turned off the machine cannot take water
in and P2 icon will flash on the programme
indicator. As long as the problem continues,
washing programme is paused and the
water inlet is checked regularly by the
machine; when the water is restored P2
icon will disappear after a while and the
washing programme resumes.
Overflowing warning
If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and P1
icon will flash on the Programme indicator.
As long as the overflowing continues safety
algorithm will be active and try to discharge
the water. If overflowing stops and safety is
assured, P1 icon will disappear. If P1 does
not disappear, there is a permanent fault. In
this case the authorised service should be
contacted.
4 doses of rinse aid are dispensed in P:5
position.
