18/EN
To avoid this, it is recommended to clean
the detergent cartridge thoroughly once in
two or three months.
You can soak it in lukewarm water, and you
can can wash with tap water.
This way, dosing problems caused by
accumulated detergent residues, as well
as blockage of the warning mechanism is
prevented and it is ensured that the system
works properly.
If a different brand or type of liquid/
gel detergent will be used, make
sure previous detergent is depleted
completely and then remove and clean
the liquid/gel detergent tank under tap
water.
Fill the rinse air box only with rinse aid,
and the detergent box only with liquid/
gel detergent.
If you fill it inappropriately, immediately
remove the boxes, empty them and
clean under running water.
Installing/Removing the Liquid/Gel
Detergent and Rinse Aid Box
Top remove the rinse aid and detergent
boxes, push and lift the system cover on
both sides as shown with arrows 1 and 2
and open.
1
2
1
Lift and remove the rinse aid box (A).
A
B
1
2
When the function is active, its indicator
comes lit and the system uses appropriate
amount of detergent and rinse aid in each
washing program.
Press the key again to cancel the
function.
When automatic liquid/gel detergent
dosing function is selected, do not use
other types (powder, tablet, etc) of
detergents.
If you want to use another type of detergent
while the automatic liquid/gel detergent
dosing system is full, cancel the automatic
liquid/gel detergent dosing function on the
control panel. Then you can use powder,
tablet or liquid/gel detergent.
Use only liquid/gel detergent suitable
for the dishwasher.
Do not mix different brands of liquid/gel
detergents.
Do not fill the liquid/gel detergent
box with liquids or chemical cleaners
(vinegar, bleacher etc.) other than
liquid/gel detergent.
Liquid/gel detergents that lost their
fluidity and became firm must not be
used in automatic liquid/gel detergent
dosing system.
Liquid/gel detergents must be used in a
short time once they have been unpacked.
Unpacked liquid/gel detergents may lose
their fluidity in time.
When the detergent warning lamp
gives a warning, it will go away in a
short while after you add liquid/gel
detergent. If the warning light is still on
after a washing cycle, you can remove
the detergent cartridge, shake it a few
times and reinstall it.
This may occur because of the blockage
of the warning gauge due to the detergent
residues remained in the cartridges after a
long term use.
