Beko DCU 7330 X, Руководство пользователя

Страница: 25 / 44

25 EN
2
Installation
Refer to the nearest Authorised Service Agent for
installation of your product.
C
Preparation of location and electrical
installation for the product is under customer’s
responsibility.
B
Installation and electrical connections must be
carried out by a qualified personnel.
A
Prior to installation, visually check if the product
has any defects on it. If so, do not have it
installed. Damaged products will cause risks for
your safety.
Appropriate installation location
• Install the product in an environment which has
no risk of freezing and is in a stable and level
position.
• Operate your product in a well ventilated, dust-
free environment.
• Do not block the air ducts in front of and under
the product with materials such as long pile
rugs and wooden bands.
• Do not place your product on a long pile rug or
on similar surfaces.
• Do not install the product behind a door with a
lock, sliding door or a hinged door which can
strike the product.
• Once the product is installed, it should stay at
the same place where its connections have
been made. When installing the product, make
sure that the rear wall of it does not touch
anywhere (tap, socket, etc.) and also pay
attention to install the product at a place where
it will stay permanently.
B
Do not place the product on top of the power
cable.
• Keep at least 1.5 cm distance to walls of other
furniture.
Removing the transportation safety
assembly
A
Remove the transportation safety assembly
before using the product for the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it from its
section marked with XX.
3. Pull the nylon towards yourself and remove the
transportation safety assembly.
A
Make sure that you have removed the
transportation safety assembly (nylon+styrofoam
pieces) before using the product for the first time.
Do not leave any items inside the drum.
Under counter installation
• A special part (Part no. 297 360 0100) replacing
the top trim must be provided and installed by
the Authorised Service Agent in order to use the
machine under a counter or in a cupboard. It
should never be operated without the top trim.
• Leave at least 3 cm of space between the side
and rear walls of the product and the walls of the
counter/cupboard when installing your product
under a counter or in a cupboard.
Mounting over a washing machine
• A fitting device should be used between the
two machines when installing above a washing
machine. The bracket (Part no. 297 720 0200
white/297 720 0500 grey) must be installed by
the Authorised Service Agent.
• Place the product on a firm floor. If it will be
placed on top of a washing machine, the
approximate weight of both machines may reach
180 kg when they are full. Therefore, the floor
must be capable of carrying the load on it!
Connection to water drain;
In products equipped with a condenser unit the water
accumulated during the drying cycle is collected in
the water tank. You should drain the accumulated
water after each drying cycle.
You can directly send the accumulated water out
through the water drain hose supplied with the
machine instead of periodically draining the water
collected in the water tank.
Connecting the water drain hose;