Beko DC 1160, Инструкция по эксплуатации, Страница: 16 / 64

16 EN
6
Solution suggestions for problems
Problem Cause Explanation / Suggestion
Drying process
takes too much
time.
Cover filter and filter drawer
might have not been cleaned.
* Meshes of the filter may be clogged.
Wash with water.
Laundry come
out wet at the
end of drying.
* Cover filter and filter drawer
might have not been cleaned.
* Excessive laundry might have
been loaded in.
* Meshes of the filter may be clogged.
Wash with water.
* Do not overload the machine.
Machine does
not switch on or
the programme
does not start.
Machine is not
activated when
set.
* It might have not been plugged
in.
* The loading door may be ajar.
* Programme might have not
been set or the «Start/Pause/
Cancel» button might have not
been pressed.
* «Childproof lock» might have
been activated.
* The condenser cover on the
models with a condenser might
not be closed securely.
* Make sure that the machine is
plugged in.
* Make sure that the loading door is
properly closed.
* Make sure that the programme
has been set and it is not in “Pause”
mode.
* Deactivate the childproof lock.
* Make sure that the condenser cover
and the red lock is closed securely.
Programme has
been interrupted
without any
cause.
* The loading door may be ajar.
* Electricity may be cut off.
* Make sure that the loading door is
properly closed.
* Press «Start/Pause/Cancel» button
to start the programme.
Laundry has
shrunk, become
felted or
deteriorated.
* A programme suitable for the
laundry type might have not been
used.
* Dry only the laundry which is suitable
for drying in your machine after
checking the labels on your clothes.
* Select a programme with suitable
low temperature for the laundry type to
dry your clothes.
Drum lightning
does not come
on.
(for models
equipped with a
lamp)
* The machine might have not
been started by using the On/Off
button.
* Bulb may have blown.
* Make sure that the machine is On.
* Call the authorized service to replace
the bulb.
“Final / Anti-
creasing” LED
flashes.
* The 2-hour anti creasing
programme to prevent laundry
from creasing might have been
activated.
* Turn off the machine and take out
the laundry.
“Final / Anti-
creasing” LED
is on.
* Program has come to an end.
* Turn off the machine and take out
the laundry.
The “Drying”
LED flashes.
* A heat sensor failure has
occurred. Machine ends the
programme without heating.
* Turn off the machine and take out the
laundry. Call your authorized service.
“Filter cleaning”
LED flashes.
* Filter might have not been
cleaned.
* Clean the cover filter.
Also for products equipped with a condenser
“Water tank”
warning LED is
on.
* Water may be full.
* Anti-creasing programme might
be running.
* Drain the water in the water tank.
“Condenser
cleaning” LED
is on.
* Filter drawer/Condenser might
have not been cleaned.
* Clean the filters in the condenser/
filter drawer under the kick plate.
A
Call an authorized service agent if the problem persists.