Beko CM300, Инструкция по использованию

Страница: 10 / 24

Appliance operation (multimode)
Temperature adjustment
The temperature in the cabinet may be
adjusted by turning the knob slightly left or
right in each function sector. To left for higher
temperature and to right for lower
temperature.
The achieved temperatures can vary
according to the conditions of use of the
appliance, such as: place of the appliance,
ambient temperature, frequency of door
opening, extent of filling with food of the
appliance. The position of the thermostat knob
will change according to these factors.
The appliance is designed to operate in three
ways.
It can operate as a:
1. Refrigerator;
2. Chiller;
3. Freezer.
Using the unit as a refrigerator
At the refrigerator setting on
the knob, the temperature in
the cabinet will be about 5°C.
This temperature is ideal for
storing
perishable foods
such diary products, fresh
vegetables and cold meats.
Cold drinks can also be stored at this
temperature. The load can be introduced
gradually in quantities not bigger than 50kg or
50l, on intervals of 15-20 hours.
Using the unit as a chiller
At the chiller setting on the
knob, the unit may be
compared with
a butcher’s
cold storage facility. The
temperature in the cabinet
can range from 3°C to -2°C.
This temperature is ideal for
storing meat or fish for short
period.
The advantage is that the food can be cooked
without first defrosting it. The load can be
introduced gradually in quantities not bigger
than 50kg or 50l, on intervals of 15-20 hours.
Using the unit as a freezer
At the freezer setting on the
knob the temperature in the
cabinet will be around -18°C.
This temperature is ideal for storing frozen
foods for long periods of time. For freezing of
the fresh food it is possible after min. 20 hours
of operation.
In Freezer operation mode is
necessary to use the
obstructing plug (item 8.)
In Fridge and chiller operation
mode the obstruction plug
(item 8.) will be removed.
The signalling system is placed on the front
side of the appliance (Item 5).
It includes:
1. Thermostat adjustment knob
– the inside
temperature is adjusted.
2. Green LED
– shows that the appliance is
supplied with electric energy.
3. Red LED
– damage – lights if the
temperature in the compartment is too high.
The LED will operate 15-45 minutes after the
putting into operation of the appliance, then it
must go off. If the LED goes on during the
operation, this means that defects have
occurred.
4. Orange LED indicates that the compressor
is running.
The three LEDs give information about the
mode of operation of the appliance.
Advice for food conservation
Fridge & chiller operation.
Avoid a position of the thermostat box outside
the ranges “Fridge” & “Chiller” which could
lead to negative operation temperatures of the
appliance, in this way exceeding temperatures
below the intended range, with the danger of
the freezing of the beverages and of the fresh
food, and excessive build-up of ice on the
walls of the cabinet liner. You do not need to
remove these drops, because the water which
results is collected by the special channel in a
small tray placed on the rear side of the
appliance, from where it evaporates.
4
EN
Instruction for use