Beko BA 310 AC, Инструкция по эксплуатации

Страница: 245 / 332

21 / 21 EN
Air conditioner remote control / User Manual
21 / 108 EN
3. Sleep function
The Sleep function is used to decrease energy use while you sleep (and don t need the same
temperature settings to stay comfortable). This function can only be activated via remote control.
C
Note: The sleep function is not available in Fan or Dry mode.
4. Zone Follow function
The Zone Follow function enables the remote control to measure the temperature at its current
location. When using Auto, Cool, or Heat functions, measuring ambient temperature from the
remote control (instead of from the indoor unit itself) will enable the air conditioner to optimize
the temperature around you and ensure maximum comfort.
1. Press Zone Follow button to activate function. The remote control will send temperature signal
to the indoor unit every three minutes.
2. Press Zone Follow button again to turn off this function.
C
Note:
- Buttons design is based on typical model and might be slightly different from the
actual one you purchased, the actual shape shall prevail.
- All the functions described are accomplished by the unit, if the unit has no this
feature, there is no corresponding operation happened when press the relative
button on the remote controller.
- When there are wide differences between Remote controller Illustration and USERS
MANUAL on function description, the description on USERS MANUAL shall prevail.
- This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
t Reorient or relocate the receiving antenna.
t Increase the separation between the equipment and receiver.
t Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
t Consult the dealer or an experienced radio/TV technician for help. Changes or
modifications not approved by the party responsible for compliance could void suers
authority to operate the equipment.
6 How to use the advanced functions