Beko B3WT58410M2, Руководство пользователя

Страница: 37 / 44

EN / 37
c. Rinse drawer and syphon in the sink with
plenty of warm water. Use gloves or suit-
able brush to prevent contact of residues
in the drawer with your skin.
d. Firmly fit the syphon and the drawer back
after cleaning.
7.2 Cleaning the Loading Door and
the Drum
For products with drum cleaning pro-
gramme, please see the Operating the
product section.
Repeat Drum Cleaning process in
every 2 months.
NOTICE: Use an anti-limescale suit-
able for the washing machines.
After every washing make sure that no for-
eign substance is left in the product.
If the holes on the door gasket shown in the
figure is blocked, open the holes using a
toothpick.
Foreign metal substances will cause rust
stains in the drum. Clean the stains on the
drum surface by using cleaning agents for
stainless steel.
Never use steel wool or wire wool. These will
damage the painted, chrome coated and
plastic surfaces.
We recommend you to wipe the door gasket
with a dry and clean cloth at the end of the
programme. This will remove residues on the
door gasket in your machine and prevent
formation of malodours.
7.3 Cleaning the Body and Control
Panel
Wipe the body of the product with soapy
water or non-corrosive mild gel detergents
as necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel. Do not use cleaning products
that contain bleach
7.4 Cleaning the Water Intake Fil-
ters
There is a filter at the end of each water in-
take valve at the rear of the product and also
at the end of each water intake hose where
they are connected to the tap. These filters
prevent foreign substances and dirt in the
water to enter the product. Filters should be
cleaned if they are dirty.
a. Close the taps.
b. Remove the nuts of the water intake
hoses to access the filters on the water
intake valves and clean them with an ap-
propriate brush. If the filters are too dirty,
remove them from their places with a pli-
ers and clean in this way.
c. Take out the filters on the flat ends of the
water intake hoses together with the gas-
kets and clean thoroughly under running
water.
d. Replace the gaskets and filters carefully
and tighten their nuts by hand.
7.5 Draining Remaining Water and
Cleaning the Pump Filter
The filter system in your product prevents
solid items such as buttons, coins and fabric
fibres clogging the pump impeller during
draining of washing water. Thus, the water
will be drained without any problem and the
service life of the pump will extend.